Mold remediation · Lutz, FL · February 2026

Hidden mold behind the baseboards and under the closet floor in a Lutz home

A water stain was hiding under the laminate in a second-floor master closet, with mold behind the baseboards and on the subfloor. We contained the closet, removed what couldn’t be cleaned, treated the framing, and had the subfloor at its dry goal two days later.

Mold growth on the OSB subfloor under the removed closet laminate in a Lutz home
Under the laminate and moisture barrier: a large water stain with mold growth on the subfloor.

What we found

The problem was in the second-floor master closet of a two-story Lutz home, on the wall shared with the toilet room. When we pulled the baseboards, there was mold growth behind them. We kept going and lifted the laminate: under the moisture barrier was a large water stain with a large area of mold on the subfloor.

The toilet room on the other side of the wall had a smaller area of growth behind the toilet. The rest of the master bath was clean.

What we did

We set containment with zipper doors on the closet and the bathroom, then removed about 90% of the closet laminate and its moisture barrier. On the closet wall we made a 2-foot cut and extended it 1 foot past the last visible growth. In the toilet room we cut 1 foot of drywall behind the toilet and 1 foot on either side.

The moldy baseboards and drywall were bagged inside containment and taken off site. A 6-inch inspection cut in the subfloor showed no growth on the underside, so the subfloor could stay. We scrubbed the studs and subfloor, applied antimicrobial, and set a dehumidifier and a HEPA air scrubber in the closet. We took down the temporary containment on the master bath so the homeowners could keep using the shower and sinks.

Mold behind the baseboard in a Lutz master closet after the lower wall was cut open
Behind the baseboard: growth on the bottom of the wall, cut out 1 foot past the last visible spot.
Moisture meter checking the closet subfloor during drying in Lutz
February 25: the closet subfloor on the meter’s relative scale, where higher means wetter. The log above uses a different scale.

Closet subfloor readings

Meter reading at each visit. The dashed line is the dry goal of 17.

Day 0Feb 24
Day 1Feb 25
Day 2Feb 26

Source: Tidal drying log for this job, recorded in Albi.

How we knew it was dry

  1. February 24 · Baseboards and laminate pulled, mold found and removed, studs and subfloor scrubbed and treated with antimicrobial. Containment, dehumidifier and HEPA air scrubber set. Subfloor reading 99. Indoor humidity 35%.
  2. February 25 · Subfloor down to 36. Indoor humidity down to 28%.
  3. February 26 · Subfloor at 17, the dry goal. Indoor humidity 20%. We sealed the closet subfloor with an encapsulating paint before the rebuild.
  4. Early March · Rebuild: new drywall, new laminate in the closet, baseboards reset, and paint.
Moisture meter readings from the Albi drying log.
RoomSurfaceFeb 24Feb 25Feb 26Goal
Master closetSubfloor99361717
Indoor conditions in the containment area, from the same log.
Feb 24Feb 25Feb 26
Temperature75°F72°F72°F
Relative humidity35%28%20%
Grains per pound453323
Moisture meter showing a lower reading on the same closet subfloor after drying in Lutz
February 26: the same spot the next day, at about half the reading.
Lutz master closet after rebuild with new laminate flooring and baseboards
After the rebuild: new laminate, baseboards and paint.

Mold in your Tampa home or business?

Every mold job we take follows the same steps: contain the area, remove what can’t be cleaned, clean and treat what stays, and dry the structure. Testing and clearance are done by an independent licensed assessor, not by us. Read how our mold remediation in Tampa works, or call our Tampa office at (813) 510-6137.